CCP Series High Voltage Capacitor Charging DC Power Supply

Introduction
The CCP series high voltage switching mode DC power supply specially designed for capacitor charging, compared to traditional linear HV power supply, it has faster response time and higher efficiency, also it has high precise and adjustable output voltage, featured current-limit working mode and unique discharging circuit which better suit capacitor charging requirements.

Features

1. Continuous DC operation or capacitor charging application
2. Output 0-10kV adjustable from 0 to 100%
3. Constant current output
4. Charging in constant current mode and switch to constant current mode till fully charged.
5. Unique double isolated system, strong anti-interference ability.
6. Forced air cooling, very rugged design
7. Local or remote control (optional)

Technical Specification

1. Input Voltage: 220V±10%
2. Output Power: 2KW ~ 60KW
3. Output Voltage: 5KV/10KV/20KV/30KV/60KV/80KV/100KV/120KV (for other output voltages, please contact us), adjustable output voltage.
4. Output polarity: positive or negative
5. Output adjusting mode: potentiometer or 0~10V analog signal control or RS port.
6. Line regulation: ≤0.5%
7. Load regulation: ≤0.5%
8. Ripple: ≤0.5%
9. Total Efficiency: ≥85%
10. Protection
    1. Input over load protection
    2. Over temperature protection
    3. Short-circuit protection
    4. Load discharging protection
11. Cooling: Forced air cooling
12. Dimension: as per output required
13. Weight: as per output required

Environment conditions

1. Working environment conditions:
2. Temperature: 0℃ ~ 40℃
3. Relative humidity: <90% (non-condensing)
4. Height: 4000m
2. Storage environment conditions:
3. Temperature: -20℃ ~ 60℃
4. Relative humidity: 10% ~ 90%
5. Height: 4000m

Safety caution

1. This power module has HV output, only professional person could operate it.
2. Please check power module as below before start-up

1. Keep power module clean and good ventilation.
2. HV input & output connectors or HV load no touch anything.
3. Please check back current of load well connected with GND bolt at the back of power module.